Automotive valve oil seal product introduction:

Automobile valve oil seal is a kind of automobile oil seal. It is made of vulcanized by exoskeleton and fluoro rubber. Valve oil seal is a component in automobile engine.

Disassembly process of automotive valve oil seal:

1: Disassemble the crankshaft and the night pressure tappet and store it downwards. When using it, be aware that the tappet cannot be exchanged. Use the spark plug wrench 3122B to disassemble the spark plug, adjust the live race of the opposite cylinder to the top dead center, and screw the hose VW653/3 into the spark plug screw opening. :

2: Use the anchor screw to place the elastic yellow compression tool 4952 on the cylinder block, adjust the relevant cylinder to the proper position, and then connect the pressure hose to the air compressor (gas pressure is not much 605kSa). Use the pitch mandrel and the thrust member to spring the diastolic cylinder and remove the yellow. The gas lock block can be removed by tapping the cylinder and the yellow seat. Pull out the valve stem oil seal with Gongbei 3332.

3: Install the plastic sleeve (A in Figure (3)) on the cylinder rod to prevent damage to the new cylinder rod seal. Lightly apply the layer of gear oil to the skeleton seal lip. The oil is packaged onto the work 3365, and then the valve seat is gradually pushed down. Special reminder: Install the inlet and intake valves, and apply the layer of transmission oil on the cylinder rod.

The above is the disassembly process of the auto valve oil seal that I have summarized for you, as well as the introduction of the product. I hope everyone has a deeper understanding of the valve oil seal.